V3 gearbox trigger problem

[SGT_Blaster]

Hi

I have some trouble with my gearbox v3 of my g36. It happen after i open the mechbox to change the cylinder. When i shoot in semi auto the trigger dont return in place after every bbs i need to replace in place the trigger to re shoot bbs i make a mini video to show you YouTube- trigger semi auto problem gearbox v3



thank

[CDN_Stalker]

How many times have you tried to fix it after the first opening? Likely it's just a small misalignment issue that is causing a bit of resistance in the trigger group that causes it to not return. Or, your spring tail isn't in the right place.

[m102404]

The only thing that makes the trigger return is the trigger spring. Is it installed correctly (short arm in the hole in the mechbox shell...long arm on the middle of the trigger)?

Tys

[SGT_Blaster]

Originally Posted by CDN_Stalker

How many times have you tried to fix it after the first opening? Likely it's just a small misalignment issue that is causing a bit of resistance in the trigger group that causes it to not return. Or, your spring tail isn't in the right place.

I open the mechbox just one time . I want to change a couple of thing in my mechbox right now and before i open the mechbox i want to know where to look i wiil check this spring thank

[SGT_Blaster]

Originally Posted by m102404

The only thing that makes the trigger return is the trigger spring. Is it installed correctly (short arm in the hole in the mechbox shell...long arm on the middle of the trigger)?

Tys

If this spring is in right place can another piece can make this problem ?????

[CDN_Stalker]

If there's enough resistance, yes. Open it up a few more times as needed, sometimes it'll take a couple tries to get it sorted out. Nothing is broken, it's just one of the trigger parts being finicky because of the way you assembled it.

[SGT_Blaster]

Can me a shimming problem ???? CAn be when i reclose the mechbox i drop a shim ??? thank for the advice i will re -open and try

Originally Posted by CDN_Stalker

If there's enough resistance, yes. Open it up a few more times as needed, sometimes it'll take a couple tries to get it sorted out. Nothing is broken, it's just one of the trigger parts being finicky because of the way you assembled it.

[CDN_Stalker]

You could empty the mechbox of everything and reassemble with just the trigger components, and it can still do the same thing. There's a chance the trigger spring isn't positioned properly, the bent part has to sit inside the hole on the trigger, and the tail has to lie on the mechbox side. V3 triggers have caused me more headaches than V2 just because there are more parts involved. You'll get it if you open it and see how the trigger works, then reassemble. Part of the learning curve.

[SGT_Blaster]

good thank i will do that

[buellxbk]

This could not be more timely. I just put my V3 back together and I new I had the spring in wrong or at least I assumed I did after rewiring. I couldn't find any reference for were it should go so thanks loads guys, saved me from having to ask. Sometimes not matter how careful you are something will escape your notice.

[CDN_Stalker]

No matter how experienced one is.

[Dirty Deeds]

To me that trigger looks a little tight. Anyhow follow the others directions as they are not steering you wrong. V3 triggers.....bahhhh

[SGT_Blaster]

I dont want to start a nother post but if a couple of hole where i put screw in my gearbox start to strip and i want to change my mechbox shell I know Tm is compatible in a lot of brand but if cyma will work in my gun ????


Thank

[SGT_Blaster]

thank guy