G&G GR25 Magazine

[Reaver_RRTS]

Ok, I'm sure this has been mentioned, but I can't seem to find it on here, so I'm making a post...

Research on the internet is inconclusive, some say it can't be done, some say it can... but...

Is there ANY SR-25 magazines NOT made by G&G (I'm looking specifically for MID-CAP) that will fit the GR25. I know that many on the internet have asked this, and there's just so many posts saying it can't then someone says it can they did it ya-da ya-da ya-da...

So if anyone has any actual legitimate knowledge about this.. please reply.

[Maalkus]

The Magpul PTS 20LR 7.62mm style PMAGs work great in my G&G GR25 (SR25). They hold 140 rounds.

[Reaver_RRTS]

Was actually looking at that just a few minutes ago. If I could find some that were in stock I'd order a few for sure. Ehobby has em for like 15 bucks but they're out of stock. Where did you buy them?

[sab567]

I personnaly use CA andGP SR25 magasin to fit in my G&G. You have to cut a little 1mm to the rear of the hole to hold the mag withthe mag cath to fit correcly, but the magasinne are cheaper (about 15$ each) and full metal. I'll add some pic if you request for.

There is a super link to use for G&G SR25 to know wich part are compatible with each other brand:
http://www.airsoftforum.com/board/SR...e-t245076.html

[Reaver_RRTS]

See, so many sites say CA and GP mags WON'T fit in the G&G, like wtf is it hit and miss with QC or what??? I'd like to get the cheaper magazines to save money so CA mags might do... I'd appreciate pictures. They'd help a ton. Thanks

[sab567]

there it is.
As you can see, you have to do a little cut (about 1mm) to be sure the mag cath will do their job correcly.
I have 9 mag, a mixt of G&P and CA mag and have no problem.

[Reaver_RRTS]

Should be easy enough... Thanks! Not sure how I'll cut it yet though lmao. But otherwise they fit fine? The dimensions are good otherwise? Any wobble/too tight etc?

[sab567]

Personnaly I use a Dremel with a "mini grinder" to cut the up and down line and use a simple metal pin to ply the little piece and it cut itself.

[Reaver_RRTS]

Ahhh gotcha... and a little sandpaper to dull the edge