WEll MB-03

[ryan23474]

Hey, I just got a WELL MB-03 sniper, and I had a problem with it after assembly. When you pull the bolt back, it doesn't cock. No click even. I'll pull it as far as it'll go, but nothing happens. I don't really want to void the warranty by taking it apart until I know for sure if it'll fix it. I ordered it off of Airsplat.com, and all the reviews say its a decent gun after you fix the slamfiring problem. Any advice would be great.

[Gunny_McSmith]

do you feel any resistance when pulling the bolt back? (because of the spring)

[Ayashifx55]

if he means theres no click and doesnt cock, means theres no resistance. I think the spring is un-alligned. I don't know the word for this but it happened to me few times on the mb05 where i could pull the bolt as i wish without any resistance. The bolt was like "free"

I took it apart and re-asssembled it and it worked. You will have to disassemble it and re-assemble it. You have no choice ... there's no magic key for that.

[Treefingers]

This is most likely caused by the sear not catching the piston. The only way to fix it is to take it apart and fix the trigger assembly.

[Kos-Mos]

Ever tried to re-engage the spring-guide retainer?

That is the pin that goes into the cylinder that holds the spring when you cock.

You have to remove the receiver assembly to check/re-engage it.

Just remove the screws under the stock, front of the trigger guard.

Then pull on the barrel up in a rotation from the trigger. The rear part of the trigger guard is keyed to the stock.

Look on the sides of the trigger unit, there is a little button that can be slided up and down. It should be completely up.