KJW M9 Full Metal problems

[fumoffu]

Hey guys currently got a slightly used KJW Beretta and the part 65 was missing.
So I replace the part 65 but the gun would not fire. So far the Part No.64 connecting to part 65 would not catch the hammer. If it does it would not release the hammer.


Oh also what is a good tool remove pins from the gun? I know you can hammer it out but I would not like damaging the pins. Any recommendation?


Thanks for the help!
Cheers,
David

[juicy]

The hammer should catch. Trigger bar spring shouldn't make a difference if the hammer catches or not. Are you sure you've installed the spring properly? This would prevent the trigger from causing the hammer to drop. I know there's a picture of how the trigger bar spring should be installed properly... the parts diagrams suck at explaining that much, lol.

Oh here we go: http://www.airsoftcanada.com/showthread.php?t=98586. See post #4... There's a nice depiction of what it should look like.

[The Chad]

Removing the pins with a center punch should work. Or another pin. Unless....no.....well......if you had a REALLLY big magnet......LOL