Quote:
Originally Posted by Gunk
I still see wires!!! (I know it's still in build phase... but they bother me  )
Are you going to put something over the entire body? Or just tuck the wires inside somewhere? And what about the front end of the grenade launcher? Are you going to mod up something that still allows BB passage, but looks nifty?
I suppose I could go back and read... but it's the time of the shift when I don't have lots of time...
And I still wanna see the finished result! |
Sorry on the wires.... They were there for testing some of the electronics. Yea there will be a full body created (hopefully for it) which is why i went with a gunbase with a lot of RIS. Yes there will also be a section built around the grenade launcher. I think i need to lower that down using Scope 20mm Weaver rail Base's, i may alsoadd a full gun length upper rail sustem to add the section above the Flash Hider.
There's alot of work to do still.
Quote:
Originally Posted by Muffin
Why'd you get a stick batt for a full stock?
|
Well... The AGM HK416 base had a mini Tamiya connector on he end. My mp5k also uses a stick battery so i just borrowed it to connect up for testing. I still have to decide on Li-po, or 12V Ni-Mh battery pack so i'm using this for now.
Also.... The G&P stock inner design is better than the CA one i have but the CA one is far superior.... Stronger/Metal Buttplate not plastic, Far better battery compartment opening.... To be honest this G&P is turd in comparison... Just the fact that there was less inside to make fitting 12v easier made me choose it.
The one good thing with this project is i get to test out and try alot of parts
