|
I tried to open the internal, but I don't have the hex needed for the ambi-selecter that needs to be removed before opening the mechbox, from what I read its standard stuff, defintly lower quality than whay you want to compare with but still solid to run stock. once I get the tools I need I'm just going to replace the plastic 7mm bushing (thats what I think they use have to check again) with metal and maybe metal cylinder head with those suobro stuff.
I don't have anything to compaire the nozzle to even if I get it appart, so I'm no good on that area, the most I can do is give a measurement. If anyone know this please add in some input.
I believe this was on another thread, and there were no conclusive answer given.
|