Quote:
Originally Posted by aerodrew
Went to power edge to test it out.
This gun clocks in at 391 FPS at the very highest. I was able to fix some of the problems by sanding the slide rails in the frame a lot. I also installed a guarder recoil spring. Now, it doesn't have any problems jamming. The last thing I'm going to change is the sear. I have a carom shot sear on order right now. The stock sear I have is worn down quite a bit and it affects performance drastically. Also, one thing about this setup is the tanio koba one touch joint compensator. Whenever I would fire the gun, the recoil would unseat the joint and it would spin. I was able to fix it by wrapping teflon tape around the joint's threads. I was also able to keep my v12 barrel straight by putting teflon tape on the threads to the chamber.
|
If you install that sear, you'll also need to replace your hammer with a steel one. Otherwise, the steel sear will quickly eat away at an aluminum hammer. I've had that happen to two hammers on two different guns now using steel sears made by Carom