Took some advice from ILLusion on building this gun, and this is what happened:
The breakdown of those parts is as follows:
Slide, Barrel and Chamber: Shooter's Design Springfield V12
Inner Barrel: PDI 7 Inch 6.01 tightbore
Hop Up Rubber: Nineball Air seal packing(the purple one)
Loading Nozzle reinforced by Guarder
Nineball dyna-piston inside loading nozzle
Trigger: PDI 3 hole
Hammer: PDI ring hammer(modified)
Magazine Valve: Tanio Koba High-flow
BB in hammer spring compartment
Freedom Art G-MT frame with comp block(note the scope mount is not attached)
Tanio Koba One-touch joint hider with short compensator(this one was pretty hard to get, but covers up the inner barrel mostly)
Optics: Burris Fastfire mounted to Shooter's Design Sightbase(very hard to find a retailer with these in stock)
Grip: Tanio Koba Finger-fits tactical grip
it took me about 7-8 months to make get to where I am right now with this gun, after going through dentrinity, redwolf, UNcompany, wgc, power edge and tokyo model and then countless other online optics retailers before i finally got the burris fastfire.
I know the lighting isn't the best in these pics, but I'll post some better ones later.
any comments/critiques welcome.