I designed the profile to fit first with my Desert Locust goggles, so the profile is near perfect. I also trimmed the bottom of the mesh which I find can get in the way if you ever need to look down or to the side.
The one thing I didn't account for when cutting the mesh was the 1/8" overhang of the fabric where it meets the mesh. As a result the tip of the nose is pushed a bit lower leaving a small gap between at the nose of the goggles. The bottom of the Revisions still mate perfectly with the mask.
With my I-Force goggles the fit is also pretty good. Obviously because these types of goggles are so low-profile its almost impossible to cover your full nose as soon as you trim it.
