Quote:
Originally Posted by Stealth
Your wires may have to be re-arranged a little bit to route them around those raised sections.
They are there to keep the wires better separated.
When installing the grip, often it's helpful to completely remove the motor height adjustment bolt, and observe the motor is perfectly centered over the hole. If it's not then you'll run into adjustment problems. Hope this helps.
|
Quote:
Originally Posted by Kos-Mos
If I remember correctly, you have to re-route the wires around the motor (stock usualy has both wires at rear, you need one front and one rear).
It might be the reason why your adjustment does not work.
Also, when loosening the adjustment screw, knock on the side of your grip a few times to let the motor pull back (It's held in place by a spring and might be caught in a wire).
|
Thanks for the replies guys. I forgot to bring it to work with me but I'll attempt to reroute the wires when I get home.