Airsoft Canada - View Single Post - Is this a good way to swap from CQB to Field?

lurkingknight · February 14th, 2013, 10:02

you'll need to replace your cylinder to support the 500mm barrel. Full cylinder, no opening. This will make some readings a bit wonky when you use heavier ammo with your cqb setup, but it will allow you to hotswap barrel setups. You'll most likely retain your fps though, maybe gain 10-20fps depending on how the air seal works out with the increased air. If you don't change the cylinder, you could lose FPS with your longer barrel.

6.01 is not as tolerant to variations in BB size or dirt in the barrel, they have the potential to jam up more.

A prometheus EG 6.03 is a great barrel. If you ant to save money, I've had good results with madbull python 6.03s.

February 14th, 2013, 10:02	#2
lurkingknight "bb bukakke" KING! Trader rating Join Date: Jul 2011 Location: Ottawa	you'll need to replace your cylinder to support the 500mm barrel. Full cylinder, no opening. This will make some readings a bit wonky when you use heavier ammo with your cqb setup, but it will allow you to hotswap barrel setups. You'll most likely retain your fps though, maybe gain 10-20fps depending on how the air seal works out with the increased air. If you don't change the cylinder, you could lose FPS with your longer barrel. 6.01 is not as tolerant to variations in BB size or dirt in the barrel, they have the potential to jam up more. A prometheus EG 6.03 is a great barrel. If you ant to save money, I've had good results with madbull python 6.03s. __________________ I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.