Absolutely this...
Quote:
Originally Posted by Danke
1) Put pressure on the "green" part while pressing the pin through.
2) Put a pin through the opposite side to locate the holes, put a second pin through and as you push it in you'll knock out the first one.
3) Make sure the pins don't have a particular orientation or a knurled end.
|
Works for me, tap in one side and then tap in the other and they will align slowly, and if you have to apply a bit of pressure to squeeze them together, and make sure you don't have too much "gunk"/sealer in there. You can't compress that.
You can tap the one pin in on one side and leave it out, flip it over and use a roll of tape to prop up the mag and tap the other pin in from the opposite side.