Airsoft Canada - View Single Post

Qlong · December 14th, 2011, 10:52

I see very little compatibility issue, it's only a tab that is being fixed onto the exterior of the existing safety. The Krebs custom safety is another story.

Since it is being riveted, take the safety off the gun. Plus, you are going to have to drill into steel so there's a good chance once that last millimeter of steel is drilled away, you might end up forcing the bit into the receiver.

December 14th, 2011, 10:52	#2
Qlong Division Trader rating Join Date: Jun 2007 Location: Scarborough, Ontario	I see very little compatibility issue, it's only a tab that is being fixed onto the exterior of the existing safety. The Krebs custom safety is another story. Since it is being riveted, take the safety off the gun. Plus, you are going to have to drill into steel so there's a good chance once that last millimeter of steel is drilled away, you might end up forcing the bit into the receiver. __________________ Weee!