|
If you only have 1/16 left, then you should not have to cut it.
Just place the barrel in there. When you reach the end, pull back on it for about 1/8" and then push back again.
Repeat until the rubber position itself properly.
Yes, it works, just takes time.
Other than that, I have just (as in 2 hours ago) installed a Madbull V2 tightbore into a TM AUG. Fitment was nice, but the outer diameter is definitely smaller. The guarder clear rubber I installed was sloppy a bit until I insert it into the chamber.
__________________
Quote:
Originally Posted by Drake
Damnit, don't make me add "no discussing temporal paradoxes" to the rules or I'll go back in time and ban you last week.
|
|