Airsoft Canada - View Single Post

Jackarutu · February 24th, 2010, 01:20

"And the reason you dont slice or cut up your rubber is simple, it can compromise the shape and strength of the rubber causing it to go out of alignment with the Inner Barrel."

I just don't get this. I was speaking of trimming off just a 1/16 inch from the end opposite of the bucking by pressing both sides together and using a razor to make a very fine slice so that when the rubber stretches as you slide the inner barrel home it doesn't pull back into the clip slot. I can't see how this could interfere with the action of the bucking. I think we are two people divided by a common language

February 24th, 2010, 01:20	#9
Jackarutu Trader rating Join Date: Sep 2009 Location: louisiana	"And the reason you dont slice or cut up your rubber is simple, it can compromise the shape and strength of the rubber causing it to go out of alignment with the Inner Barrel." I just don't get this. I was speaking of trimming off just a 1/16 inch from the end opposite of the bucking by pressing both sides together and using a razor to make a very fine slice so that when the rubber stretches as you slide the inner barrel home it doesn't pull back into the clip slot. I can't see how this could interfere with the action of the bucking. I think we are two people divided by a common language __________________ I must not fear. Fear is the mind-killer. Fear is the little-death that brings total obliteration. I will face my fear. I will permit it to pass over me and through me.