Quote:
Originally Posted by flack
You need to take a flat screw driver and a hammer... im not kidding! put the screw driver just on the side of the cylinder cover in the front and hit gently... There is only 2mm thick of material so be carefull! And dont forget to remove the E clip holding the fake bolt to the piston rod
i just finished to put it back together and thrust me, the blowback assembly is a pain in the ass to assemble/disassemble!
|
I've already done the whole smacking it back part, lol. Although it only goes so far before it cant go any further, and I'm unclear as of what to do after its been knocked back as far as it goes.