Turnigy nano-tech lipos in VFC stock tube
 

I read online one person stating that Turnigy nano-tech 1400mah lipos didn't fit in the stock tube of his VFC 416. I just ordered a VFC sr15 and was wondering if anyone can speak from experience if the battery will fit in the stock tube?

this lipo:
http://www.hobbyking.com/hobbyking/s...SOFT_Pack.html

Thanks

it'll fit, snug. the battery i run in my VFC416 is 125x20x18, but it's only 1100mAh.
likely you will not be able to collapse the stuck fully.

It will fit but you wont be able to collapse your stock fully, in my FCC 416D it's the same

I had issues fitting that battery in most of my M4 regular buffer tubes, enough that I don't use it for my M4's at all. I haven't tried it with a King Arms lipo buffer tube. If you want I can double check fitment specifically in my VFC mk12 SPR.

It will be VERY tight, get the 1300mah 3S one instead.

The three batterys stacked up aren't really any smaller than the one I listed originally though?

1300 uses longer cells so then the width and depth are a tad smaller

+1

I have a VFC M4, and I opted for the 1300 1.3 Battery...only trade off is you can't fully collapse the stock, only about 3/4s.

I thought are round Lipo batteries being developed.